Developing Microsoft System Center Operations Manager 2007 Management Packs
You configure the Event conditions above using the expressions options below.
Click here for a larger image.
Figure 11: Configuring Operation State to read Events
Now, you're ready to load the Management Pack into Operations manager and begin monitoring the sample Application instrumentation.
Navigating the Console
Below is the Operations Manager Console Application.
Click here for a larger image.
Figure 12: Operations Manager Console
Right-click Management Packs on the Administration screen to load the Management Pack.
Click here for a larger image.
Figure 13: Loading a Management Pack
It may take some time for Operations Manager to run the Discovery and find the Sample application.You should see something like the information below when the application is discovered.
Click here for a larger image.
Figure 14: Viewing a Discovery
To see the state change, press the appropriate buttons on the Sample application to change States.
Click here for a larger image.
Figure 15: Application State Changes in Operations Manager Console
Page 5 of 6
This article was originally published on April 14, 2008