October 26, 2016
Hot Topics:

Sequential to Parallel Code Transitioning Using Macros

By Peter Nikolaev Koniarov - Multiprocessor computers are very common nowadays, but the programs that make use of their advantages are quite few. This situation is mainly due to the difficulties accompanying multi-threaded design. There are ways, however, to increase parallelism at low cost. In this article I'm going to describe a method for easy transitioning from sequential single-threaded to parallel multi-threaded code using macros.

View Source

Comment and Contribute


(Maximum characters: 1200). You have characters left.



Enterprise Development Update

Don't miss an article. Subscribe to our newsletter below.

Sitemap | Contact Us

Thanks for your registration, follow us on our social networks to keep up-to-date
Rocket Fuel